Discover > Answered Question
 |
Valve clearances Honda cb100n
Asked by: Arachnoblaster
from -
|
Anyone know what the above is? The bike is a 1984 British registered CB100n-a model. I would also like to know the pilot mixture setting & the contact breaker points gap. Many thanks. A.
No Clarification Requests
Answer
|
User Rating:
 
Compliment Answer:
Answer Compliments:
0
|
I found your answer at this website
I always used 1/4 turn on the adjuster screw. Tighten the screw until it just contacts the top of the valve and then back it off 1/4 turn and hold it while you tighten the lock nut. If you feel uncomfortable with that method use .005 in on both intake and exhaust. All point gaps are .014 in. The idle mixture varys from bike to bike but I'd start with 2 1/2 turns out and ...
I always used 1/4 turn on the adjuster screw. Tighten the screw until it just contacts the top of the valve and then back it off 1/4 turn and hold it while you tighten the lock nut. If you feel uncomfortable with that method use .005 in on both intake and exhaust. All point gaps are .014 in. The idle mixture varys from bike to bike but I'd start with 2 1/2 turns out and ...
Answer Date: 11:01pm 10/13/08
